Tower Top Amplifiers
455-460MHz
• Low Loss Filter, Lightning Protection, Bias Tee
• Stainless steel canister design for less wind loading and better weather protection
• Quadrature ampliflier for better reliability, lower noise and higher IP3
• Receive Signal improvement for long coaxial cable runs
• Automatic Bypass of Top Amp
dbSpectra
08-2009
Rev. 3
1590 E. Highway 121, Building A • Lewisville, Texas 75056
Ph: 469.322.0080 • Fax: 469.322.0079 • www.dbspectra.com
dbSpectra
High Preformance
Filter
Bypass Relay
PDU
(Order Separately)
Freq. Range:
TMA Gain:
Filter Band Width:
TMA Noise Figure:
IP3 (AMP only):
Return Loss:
Power Supply Volt:
Operating Current:
Surge Suppression:
ATS7TMA22
794-816 MHz
19 dB (typ)
22 MHz
<2.5 dB (typ)
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
ATS7TMA30
794-824 MHz
17 dB (typ)
30 MHz
<2.7 dB (typ)
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
ATS8TMA18
806-824 MHz
18 dB (typ)
18 MHz
<2.5 dB (typ)
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
ATS8TMA10
806-816 MHz
18 dB (typ)
10 MHz
<2.5 dB (typ)
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
ATS8TMA3
806-824 MHz
17 dB (typ)
3 MHz
3.5 dB
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
ATS9TMA5
896-901 MHz
19 dB (typ)
5 MHz
<2.5 dB
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
DB8982Y-TMA
456-460, 466-470
16 dB (typ)
2 @ 4 MHz
4.5 dB (max)
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
ATS5TMA3
470-512 MHz
16 dB (typ)
3 MHz
4.5 dB (max)
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
ATS3TMA4
370-400 MHz
14 dB (min)
4 MHz
4.5 dB (max)
>40 dBm
14 dB (min)
15 VDC (nominal)
500 mA (typ)
18K ANSI C62.1
8/20 WAVEFORM
110 JOULES
Weight: 25 lbs (11.3 kg) Environmental Stealing: NEMA 4X
(DB8982Y-TMA / ATS5TMA3 /
ATS3TMA4): 59 (26.8)
Dimensions (WxDxH): 9 x 13.25 x 21.25 in. Outer Finish: White (UV protected)
(229 x 337 x 540 mm)
(DB8982Y-TMA) / ATS5TMA3 / 11.5 x 13.25 x 31.25 Standard Mounting Hardware: DB380, Included
ATS3TMA4): (292.1 x 336.6 x 793.8)
(Weight and dimensions include mounting brackets)
RF Connectors: Type N-Female
Temp. Range: -30° to 60° C
ELECTRICAL
MECHANICAL
700-800-900
UHF
Amp
Bias Tee
DC
Bias Tee
Power
Supply
Splitter
Tower Top Amplifiers
UHF, 700, 800, or 900 MHz
dbSpectra
08-2009
Rev. 3
1590 E. Highway 121, Building A • Lewisville, Texas 75056
Ph: 469.322.0080 • Fax: 469.322.0079 • www.dbspectra.com
dbSpectra
Test Signal Injection Option:
• Allows a closed loop RF check of the TTA system.
• Requires a second RF cable to be installed at site.
• Test signal is injected into this second cable at the PDU,
Test signal enters TTA RX path via a 30 dB coupler in
TMA enclosure.
• A test signal injection off/on switch on PDU controls a relay
in the TTA which allows the RX antenna to be disconnected
if desired from the system during test, or test can be conducted
with antenna to avoid disruption to system.
• Level of test signal can be measured at RX multicoupler output port.
• Top amp can be manually bypassed at PDU to measure closed loop
signal level with and without top amp in line to verify operation.
• Order TTA unit with “-R” for Test Port
• For DBSMCP PDU order with Alarm option that includes test port
(see DBSMCP Datasheet)
• “Test Port Injection Kit” For DBCNRX PDU order DBCN1NJKT separately
Polyphasor/
Bias Tee
Polyphasor
Polyphasor/
Bias Tee
Amp
Polyphasor/
Bias Tee
DBSMCP PDU & RX MC
Test Signal In
Test Signal Out at RX Multicoupler Port
TTA
Enclosure
2nd RF Cable for Test Injection
Main RF Cable
BOTTOM END ACCESSORIES
DBSMCP Series: Power Distribution Unit – providing alarming and power through a Bias Tee.
DBCNRX Series: PDU / Receiver Multicoupler package
with alarm and Bias Tee
ORDERING INFORMATION
Add Suffix to TMA Model Number:
-R: Test Port- Signal Injector – provides for 2nd
transmission line input for testing with control to
switch out antenna and switch in Test Port.
50 Ω
30 dB
coupler
Test Port
Injection
Relay